[andreyasb]

вроде прошилось

лог

U-Boot 1.3.1 (Nov 15 2010 - 17:57:53) - stm23_0043 - YW 1.0.018 Rel

DRAM: 128 MiB
NOR: 8 MiB
NAND: 512 MiB
In: serial
Out: serial
Err: serial
IdentID : 09 00 0b 00 00 91 c6
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force Factory mode
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading spark/mImage
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
............

5867410 bytes read
Un-Protect Flash Bank # 1
.................................................. ..............................
.................................................. ..... done

.................................................. ..............................
................................ done
Erased 112 sectors
Copy to Flash... .................................................. .............
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. .....done
reading spark/userfsub.img
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................
.................................................. ..............................





...............................

122388288 bytes read

NAND erase: device 0 offset 0x800000, size 0x17800000
Skipping bad block at 0x11020000
Erasing at 0x17fe0000 -- 100% complete.
OK

NAND write: device 0 offset 0x800000, size 0x74b7f40

Writing data at 0x792e000 -- 100% complete.
122388288 bytes written: OK
Unprotecting Flash...
.. done
Un-Protected 2 sectors
Erasing Flash...
.. done
Erased 2 sectors
Writing to Flash...
........ done
Protecting Flash...
.. done
Protected 2 sectors
0

перезагрузка опять boot и все по кругу

## Booting image at a0080000 ...
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867346 Bytes = 5.6 MiB
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970083 Bytes = 2.8 MiB
Image 1: 2897250 Bytes = 2.8 MiB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = 90b0091c6
Loading Ramdisk to 80d3c000, length 002c3562 ... OK

Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/d
ev/ram0 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255. 0.0:lh:eth0ff stmmac
eth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwadd
r:24:00:0B:00C6 Manufacture=Spark-Project STB_ID=09:00:0B:00:00C6 - 0x00
53d000 - 2897250 ...

востановительная ничего не дает проходит без ошибок.
Раз прошивка проходит без ошибок может загрузчик виноват?


а это после прошивки boot

Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
xyzModem - CRC mode, 2(SOH)/512(STX)/0(CAN) packets, 2 retries
## Total Size = 0x00080000 = 524288 Bytes
............... done
Un-Protected 15 sectors

............... done
Erased 15 sectors
Copy to Flash... ................................done
............... done
Protected 15 sectors
0

прошился и опять 25

## Booting image at a0080000 ...
Image Name: Kernel-Ramdisk-Image
Image Type: SuperH Linux Multi-File Image (gzip compressed)
Data Size: 5867343 Bytes = 5.6 MiB
Load Address: 80800000
Entry Point: 80801000
Contents:
Image 0: 2970211 Bytes = 2.8 MiB
Image 1: 2897119 Bytes = 2.8 MiB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
stb_id = 90b0091c6
Loading Ramdisk to 80d3c000, length 002c34df ... OK

Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/d
ev/ram0 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255. 0.0:lh:eth0ff stmmac
eth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwadd
r:24:00:0B:00C6 Manufacture=Spark-Project STB_ID=09:00:0B:00:00C6 - 0x00
53d000 - 2897119 ...